User Guide
Table Of Contents
- Safety Precautions
- Introduction
- Making Connections
- Using Your ViewBoard
- Powering On/Off your ViewBoard
- Initial Launch Setup
- vLauncher - Customizable Welcome Screen
- Tool Bar
- ViewBoard On-Screen Display (OSD) Menu
- Embedded Applications and Settings
- RS-232 Protocol
- Appendix
- Regulatory and Service Information
6060
Standby Mode
Decide what happens when you press the Power buon while the ViewBoard is On.
Hibernate
When enabled, pressing the Power buon will turn o the ViewBoard and the
system.
Sleep
When enabled, pressing the Power buon will turn o the ViewBoard’s backlight,
but the system will remain on.
To enable sleep mode:
1. The user needs to provide their ViewBoard’s serial number (S/N) to ViewSonic.
The S/N label is located near the I/O side.
2. ViewSonic will then provide the KEY (FakePowerO) le to the user.
3. Aer receiving the KEY le, copy the le to a USB drive.
4. Insert the USB drive into the USB port of the ViewBoard.
NOTE: The KEY le MUST match the ViewBoard’s S/N.
5. Select “Sleep”.
NOTE:
• The user does not need to restart the system.
• If the user sets the Standby Mode to Hibernate then to Sleep again, the
user needs to repeat steps 3 to 5.