User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Using the password function
- Setting a password
- If you forget your password
- Entering the password recall procedure
- Change Password
- Disabling the password function
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Adjust four corners
- Zoom in to see details
- Selecting the aspect ratio
- About the aspect ratio
- Optimizing the image
- Fine-tuning of image quality in user modes
- Setting the Presentation Timer
- Hiding the image
- Locking control keys
- Light source settings
- Extending light source life
- Operations at high altitudes
- Using the CEC function
- 3D functions
- Control the projector through the local area network
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Description of each menu
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
30
Fine-tuning of image quality in user modes
You may use several user-dened functions if the projector detects certain signal
types. You can make adjustments to these functions based on your needs.
Adjusting Brightness
Enter Image > Brightness menu and then press
/.
The higher the value, the brighter the image. And
lower the setting, darker the image.
Adjusting this control allows the black area of the image to appear just as black to
reveal details within.
Adjusting Contrast
Enter Image > Contrast menu and then press /.
The higher the value, the greater the contrast. After
adjusting Contrast, this function may be used to set the peak-white level that
matches the input signal and observed environment of your choice.
Adjusting Color
Enter Image > Advanced > Color menu and press /.
Lower settings produce less color saturation. If the setting is too high, colors on the
image will be overpowering, which makes the image unrealistic.
This function is only available when the input signals are Video, YPbPr or YCbCr.
Adjusting Tint
Enter Image > Advanced > Tint menu and press /.
The higher the value, the more reddish the picture becomes. The lower the value, the
more greenish the picture becomes.
This function is only available when the input signal is Video.
Adjusting Sharpness
Enter Image > Advanced > Sharpness menu and then press /.
Higher settings produce sharper images. The lower the value, the softer the picture
becomes.
This function is only available when the input signals are Video, YPbPr or YCbCr.