User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Using the password function
- Setting a password
- If you forget your password
- Entering the password recall procedure
- Change Password
- Disabling the password function
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Adjust four corners
- Zoom in to see details
- Selecting the aspect ratio
- About the aspect ratio
- Optimizing the image
- Fine-tuning of image quality in user modes
- Setting the Presentation Timer
- Hiding the image
- Locking control keys
- Light source settings
- Extending light source life
- Operations at high altitudes
- Using the CEC function
- 3D functions
- Control the projector through the local area network
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Description of each menu
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
39
3. You can adjust AMX and SNMP settings on this page. On the AMX device discovery,
the controller connected to the AMX of the same network will nd out the projector
when ON is selected. For details of the AMX Device Discovery, please access the
AMX website: http://www.amx.com/.
4. If the projector is connected to the network which supports the SMTP (Simple Mail
Transfer Protocol), you can congure it to send alarms via emails when important
events occur.
5. Crestron (e-Control) page display Crestron e-Control user interface. For details,
please refer to “About Crestron e-Control®”.