User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Using the password function
- Setting a password
- If you forget your password
- Entering the password recall procedure
- Change Password
- Disabling the password function
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Adjust four corners
- Zoom in to see details
- Selecting the aspect ratio
- About the aspect ratio
- Optimizing the image
- Fine-tuning of image quality in user modes
- Setting the Presentation Timer
- Hiding the image
- Locking control keys
- Light source settings
- Extending light source life
- Operations at high altitudes
- Using the CEC function
- 3D functions
- Control the projector through the local area network
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Description of each menu
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
55
Specications
Projector specications
● All specications are subject to change without notice.
● Not all projector models are available at your location.
LS625X LS625W
Input Terminals
1 VGA input (DB 15 pin) x2 x2
2 HDMI (v1.4 with audio ) x2 x2
3 Video (RCA) x1 x1
4 Audio input (3.5mm mini jack) x1 x1
5 S-Video x1 x1
Output Terminals
1 Audio output (3.5mm mini jack) x1 x1
2 USB (mini A type) 5V/1.5A x1 x1
3 Speaker x1 x2
4 VGA output x1 x1
Control Terminals
1 RS232 (9 pin 1 type) x1 x1
2 USB cable (mini B type) x1 x1
3 12V Trigger x1 x1
4 LAN x1 x1
Fuse specications
The fuse number used on the power PCB board is: F1, and the specifications are: 250V,
T6.3AH