User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Using the password function
- Setting a password
- If you forget your password
- Entering the password recall procedure
- Change Password
- Disabling the password function
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Adjust four corners
- Zoom in to see details
- Selecting the aspect ratio
- About the aspect ratio
- Optimizing the image
- Fine-tuning of image quality in user modes
- Setting the Presentation Timer
- Hiding the image
- Locking control keys
- Light source settings
- Extending light source life
- Operations at high altitudes
- Using the CEC function
- 3D functions
- Control the projector through the local area network
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Description of each menu
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
35
Extending light source life
To keep the light source life as long as possible, you can do the following settings via
the OSD menu.
Use the Power Saving mode to reduce system noise and power by 20%. If you
select Power Saving mode, the light intensity will decrease and the projection
pattern will be darker.
Switching the projector setting to Power Saving mode also extends the light source.
To set Power Saving mode, go to Advanced > Light Source Settings > Light
Source Mode, press / to select Power Saving, or press [Eco Mode] on the
remote control to make the choice.
Setting Auto Power Off
This function allows the projector to enter Sleep mode automatically after the set
time, to avoid unnecessary wastage of the light source.
1. Open the OSD menu and go to the Power Management > Smart Energy
menu.
2. Press [Enter] to display the Smart Energy page.
3. Select Auto Power Off and press / to select the time.
4. If the pre-set time length is not suitable for your needs, select Disable. The
projector will not automatically shut down in a certain time period.
Setting the Sleep Timer
This function allows the projector to enter sleep mode automatically after the set time,
to avoid unnecessary wastage of the life of the light source.
1. Open the OSD menu and go to the Power Management > Smart Energy
menu.
2. Press [Enter] to display the Smart Energy page.
3. Select Sleep Timer and press / to select the time.
4. If the length of the pre-set time does not apply to your presentation, select
Disable. The projector will not automatically shut down in a certain time period.
Set power saving
If no input source is detected after 5 minutes. The projector will reduce power
consumption to avoid unnecessary wastage of the life of the light source. You can
further decide whether to let the projector turn off after the set time.
1. Open the OSD menu and go to the Power Management > Smart Energy
menu.
2. Press [Enter] to display the Smart Energy page.
3. Select Power Saving Press / and select Enable.
4. When Enable is selected, the light source of the projector will be changed
to Eco mode 5 minutes after no signal is detected. If the projector has not
detected the signal after 20 minutes, its light source power will be changed to
SuperEco mode.