User Guide

64
5. ADVANCED menu
3D Settings See "Using the 3D functions" on page 43 for details.
HDMI Format
Settings
See "Changing HDMI input settings" on page 30 for details.
Network
Settings
Wired LAN
• DHCP: If the projector installation environment has the
Dynamic Host Configuration Protocol server. You can set this
function ON to let the projector get the auto ID from server. If
no DHCP, even you set ON for this function. You still need to
input the projector ID by yourself.
• IP Address: If has DHCP server and the function is on. The ID
address will auto display here , or you need to enter ID by
yourself.
• Subnet Mask: If has DHCP server and the function is on. The
Subnet Mask address will auto display here , or you need to
enter it value by yourself.
• Gateway: If has DHCP server and the function is on. The
Gateway address will auto display here , or you need to enter it
value by yourself.
• DNS Server: If has DHCP server and the function is on. The
DNS Server address will auto display here , or you need to enter
it value by yourself.
• Standby LAN Control: When switch on, standby mode
change to Network Standby or Normal.
• Apply: Press ENTER/ . to confirm settings.
AMX Device Discovery
When AMX Device Discovery is On, the projector can be detected
by AMX controller.
Control4
If you network environment uses a Control4 or Control4 SDDP
controller, turn on the Control4 setting to allow the projector to be
detected.
HDBaseT
See "Connecting a HDBaseT device" on page 23 for the details.
RS232 Settings
Baud Rate
Select RS232 Baud Rate.
Channel
Select RS232 control channel from Local or HDBaseT.
When select HDBaseT for RS232 control channel, change Baud
rate to 9600
Remote Sensor
Setting IR Remote Control Sensor from the projector that you
prefer.
Function Description