User Guide

42
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
POWER MANAGEMENT > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the Connection chapter.
Standy mode
When HDBaseT switch on, Standby Settings mode will change to Normal.
Green mode
Power consumption <0.5w, when selected, switch Off following function: VGA loop
through, Audio Pass Through, Standby LAN Control and HDBaseT.
Network standby
Power consumption < 2w, when selected, switch On following function: Standby LAN
Control and switch OFF VGA loop through, Audio Pass Through and HDBaseT.
Normal
Allows all standby features switch On.
VGA loop through
Enable or Disable VGA out loop through function. When switch On, Standby Settings
mode will change to Normal.
Audio Pass Through
Select Audio Pass Through from Audio in, Audio L/R, or Disable this function.
When switch On, Standby Settings mode will change to Normal.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input/output jacks. See
"Connection" on page 19 for more details.
Muting the sound
1. Open the OSD menu and go to the BASIC > Audio Settings > Mute menu.
2. Press / to select On.
If available, you can press on the remote control to toggle the projector audio between on
and off.
Adjusting the sound level
1. Open the OSD menu and go to the BASIC > Audio Settings > Audio Volume menu.
2. Press / to select a desired sound level.
If available, you can press or on the remote control to adjust the projector’s sound
level.
Microphone: On / Off
Enable or Disable microphone function.
When microphone plugged in and auto detected, priority is higher than Audio In to Audio Out.