Lamp Swapping Instruction

Replacing the lamp

Turn the power off and disconnect the projector from the power outlet.

y To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord

before changing the lamp.

y To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replac-

ing the lamp.

y Toreducetheriskofinjuriestongersanddamagetointernalcomponents,usecautionwhenre-

moving lamp glass that has shattered into sharp pieces. Before replacing the lamp, clean the lamp

compartment and dispose of cleaning materials. Be careful of sharpedges in the lamp compart-

ment. Wash hands after lamp replacement.

y OnlyViewSoniccertiedlampsaretestedwiththisprojector.Useofotherlampsmaycauseelectri-

calshockandre.

y Wear working gloves during lamp replacement.

y Unplugprojectorpoweratleast10minutesbeforereplacingthelamp.

1. Turn the power off and disconnect the projector from the wall socket. If the lamp is hot, avoid burns

by waiting for approximately 45 minutes until the lamp has cooled.

2. Loosen the screw that secures the lamp cover of the

projector until the lamp cover loosens.

3. Remove the lamp cover and mylar from the projector.

CAUTION

y Do not turn the power on with the lamp cover

removed.

y Do not insert your ngers between the lamp and the

projector. The sharp edges inside the projector may

cause injuries.

4. Disconnect the lamp connector.

5. Loosen the screw that secures the inner lamp.

6. Lift the handle so that it stands up.

2-1

2-2