Lamp Swapping Instruction
3
11. Tighten the screws that secure the lamp cover.
CAUTION
y Loosen screw may cause a bad connection, which could
result in malfunction.
y Do not over tighten the screw.
Replacing the lamp
After powering on the projector, open the OSD menu. Go to ADVANCED > Lamp
Settings > Reset Lamp Hours and press Enter. The notication message will be displayed if
you want to reset the lamp hours. Highlight Reset and press Enter. The lamp hours will be reset
to “0”.
CAUTION
y Do not reset if the lamp is not new or replaced as this could cause damage.
11-2
11-1