User Guide

Table Of Contents
2
Important safety instructions
Your projector is designed and tested to meet the latest standards for safety of information
technology equipment. However, to ensure safe use of this product, it is important that you
follow the instructions mentioned in this manual and marked on the product.
Safety Instructions
1. Please read this manual before you operate your projector. Save it for future
reference.
2. Do not lo
ok straight at the projector lens during operation. The intense light beam
may damage your eyes.
3. Refer servicing to qualified service personnel.
4. Always open the lens shutter or remove the lens cap when the projector la
mp is
on
.
5. In some countries, the line voltage is NOT stable. This projector is designed to operate
safely within a mains voltage between 100 to 240 volts AC, but could fail if po
wer
cuts
or surges of ±10 volts occur. In areas where the mains voltage may
fluctuate
or
cut out, it is recommended that you connect your projector through a
power
stabilizer
, surge protector or uninterruptible power supply (UPS
).
6.
Do not block the projection lens with any objects when the pr
ojector is under
op
eration as this could cause the objects to become heated and deformed or ev
en
caus
e a fire. To temporarily turn off the lamp, press BLANK on the proj
ector or
remote cont
rol.
7. The lamp becomes extremely hot during operation. Allow the projector to
cool for
app
roximately 45 minutes prior to removing the lamp assembly fo
r replacement.
8.
Do not operate lamps beyond the rated lamp life. Excessive operation of
lamps
bey
ond the rated life could cause them to break on rare occasions.
9. Never replace the lamp assembly or any electronic components unless the projector
is
un
plugged.
10. Do not place this product on an unstable cart, stand, or table. The product may fall,
sustaining serious damage.
11. Do not attempt to disassemble this projector. There are dangerous high voltages inside
which may cause death if you should come into contact with live parts. The
only user
serviceable part is the lamp which
has its own removable cover.
Under no circumstances should you ever undo or remove any other covers. Refe
r
servicing onl
y to suitably qualified professional service personnel.
12. Do not place this projector in any of the following envi
ronments.
- Space that is poorly ventilated or confined. Allow at least 50 cm clearance from walls
and free flow of air around the projector.
-
Locations where temperatures may become excessively high, such as the inside of a
car with all windows rolled up.
-
L
ocations where excessive humidity, dust, or cigarette smoke may contaminate optical
components, shortening the projector's life span and darkening the picture.
-
Locations near fire alarms
-
Locations with an ambient temperature above 40°C / 104°F
-
Locations where the altitudes are higher than 3000 m (10000 feet).