Lamp Swapping Instruction

2
7. Use the handle to slowly pull the lamp out of the projector.
CAUTION
y Pulling it too quickly may cause the lamp to break and scatter
broken glass in the projector.
y Do not place the lamp in locations where water might splash on
it, children can reach it, or near ammable materials.
y Do not insert your hands into the projector after the lamp is
removed. If you touch the optical components inside, it could
cause color unevenness and distortion of the projected images.
8. As show in the gure, insert the new lamp. Align the lamp
using the alignment holes and gently push the lamp into the
locked position
CAUTION
y Do not touch glass of lamp with bare hands. Oils from the skin
can create a hot spot on the lamp and may result with damage to
the lamp.
9. Insert the lamp connector and tighten the screw that secures
the lamp.
CAUTION
y Loosen screw may cause a bad connection, which could result in
malfunction.
y Do not over tighten the screw.
10. Replace the projector’s and lamp cover.
9-1
9-2
9-3