PGD-150 3D Glasses - User Guide - Bedienungsanleitung - Guía del usuario - Guide de l’utilisateu - Käyttöopas - Pyководство пользователя - 使用手冊(繁中) - 使用手冊 (簡中) Model No.
Compliance Information For U.S.A. This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Declaration of RoHS Compliance This product has been designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and the Council on restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directive) and is deemed to comply with the maximum concentration values issued by the European Technical Adaptation Committee (TAC) as shown below: Substance Proposed Maximum Concentration Actual Concentration Lead (Pb) 0,1% < 0,1% Mercury (
Copyright Information Copyright © ViewSonic Corporation, 2010. All rights reserved. ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered trademarks of ViewSonic Corporation. Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.
PGD-150 3D Glasses User Guide System Requirements The PGD-150 3D Glasses are designed to be emitter free and work with 3D enabled DLP® Link projectors and televisions. The DLP projector should be in 3D mode and displaying 3D content.
Power off Press button LED\ Shutter flashes 3 times Strong LED >0.1sec Yes Shutter on in 3D mode Press button>2.5sec No In inversion mode 3D 3D(Inverted) Battery Indicator The PGD-150 3D Glasses come pre-loaded with two coin type non-rechargeable manganese lithium batteries, and provide for up to 70 hours of continuous use. When the battery life is close to the end, the battery indicator LED will flash 4 times consecutively every 1 minute.
Step 2 Battery Removal and Replacement Use a small lever to pry out the batteries and remove them.
Fasten the screw Nosepiece Replacement The PGD-150 3D Glasses come with three interchangeable nosepieces to give you the most comfortable fit. Simply pull out the current nosepiece horizontally and insert the one that fits you best.
Packing List The following parts are included in the packing box. ․One pair of PGD-150 3D glasses ․Three interchangeable nosepieces (large, medium, small) ․User Guide Compliance & Certification PGD-150 3D glasses are compliant with the following regulations. ․FCC (Federal Communications Commission) ․CE (European Conformity) Caution ․If LCD shutters are dirty, please use soft clothes to wipe them.
Customer Support For technical support or product service, see the table below or contact your reseller. Note: You will need the product serial number. Country/Region Web Site Telephone Email Australia/New Zealand www.viewsonic.com.au AUS= 1800 880 818 NZ= 0800 008 822 service@au.viewsonic.com Canada www.viewsonic.com T (Toll-Free)= 1-866-463-4775 T (Toll)= 1-424-233-2533 F= 1-909-468-1202 service.ca@viewsonic.com Europe www.viewsoniceurope.com www.viewsoniceurope.com/uk/Support/Calldesk.