User Guide

PJ-WMK-006
Page 4
Installation Manual
Mounting
Points
Inverted
Projector
Flat
Surface
Blanket /
Soft Cloth
Figure 1. Projector Preparation
Features
Congratulations on your recent purchase of your PBC Universal Projector Mount. This mounting
system is designed for projectors weighing 60 lbs. (27.2kg) or less. The mount is easy to install and is loaded with additional installation features built
into the mount. These features allow you to optimize the projector's position to the screen for the best projector performance and picture quality.
- Can be mounted to the ceiling
- Tilt/Roll up to + 20º
- Rotates 360º
- Positive locking in any set position
- Quick release system for easy projector mounting and removal
- Cables can be routed inside pipe
- Upper ceiling plate allows for single wooden stud installation and cable insertion through the ceiling
plate for a cleaner appearance.
Projector Preparation
Proper installation procedure by qualied personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in
serious personal injury and possible damage to the projector.
THE PROJECTOR IS FRAGILE. HANDLE WITH CARE AT ALL TIMES.
Review the projector manufacturer's operation manual and refer to the ceiling mounting section of the operator's manual. Here you will normally
nd important reference information regarding installation dimensions such as distance from the screen to the lens of the projector, top of the lens
placement to the top screen etc. Adherence to those recommendations during your installation will enhance the quality of your nal image on the
screen.
Step 1. Carefully invert the projector and place it on a smooth, at surface.
Step 2. Identify the number of mounting points and screw thread size. Most projectors have either three or four mounting points and are M4, M5,
or M6 in thread size (Figure 1).