User Guide
Page 6
Installation Manual
Only attach to the projector manufacturer's specied mounting points on the projector chassis with a minimum of three mounting legs.
Please follow all safety instructions specied by the projector manufacturer as well as the safety instructions outlined in this manual.
The two-piece mounting legs are designed to allow for the positioning of each leg around projector air vents located on the base of the
projector. Where applicable, each leg mount may be shortened by removing the locking screw. This will allow for a better bracket t,
overall.
For easier installation, the mounting legs should be rst mounted to the projector. Each leg should then be adjusted so that they can
mount to the Universal Mount (Figure 3).
Step 1. Locate the mounting points on the bottom of the projector and use the appropriate number of mounting legs.
Step 2. Select the mounting hardware that the projector requires and loosely install the universal mount on the projector.
Bracket Installation
Figure 3. Projector Preparation
One Piece LegTwo Piece Leg
M5 Security
Allen Wrench
M6 x 12mm Security
Head Screw
M5 x 12mm Security
Head Screw
M4 x 12mm Security
Head Screw
M3 x 12mm Security
Head Screw
M2.5 x 10mm Security
Head Screw
Inverted Projector
Universal Mount
Leveling Barrel
PJ-WMK-006