Owner's Manual
52
Two images, side-by-side format
` Select “3D” --> “3D Format” from OSD and choose “Side-by-Side(Half)” for
input signal is HDMI 1.4a 3D. 3D Format is only supported on 3D Timing on
page 58.
Image does not display in 3D
` Check if the battery of 3D glasses is drained.
` Check if the 3D glasses is turned on.
` Select “3D” --> “3D Format” from OSD and choose “Side-by-Side(Half)” for
input signal is HDMI 1.4a 3D. 3D Format is only supported on 3D Timing on
page 58.
On Screen Messages
y Power off conrm
Power Off?
Press power key again.
y Fan lock error
The projector will switch off automatically.
Warning! FAN LOCKED
y No source found
VGA-A
No Source Found
y Out of display range
VGA
Out of display range
y Over temperature
Warning! TEMPERATURE TOO HIGH
Please:
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 40 degree C.