ViewSonic Device Manager

Using ViewSonic Device Manager
Adding Clients into a Managed Group
43
5. Select the desired client(s), the preferred client group from the drop-down menu on the top of the Client list,
and then click Put in group.
NOTE
• The default client group is Ungrouped. You can change the group of a client at a
later time. To create new client groups, please refer to section “3.4.3 Creating Client
Groups” on page 48.
• To select multiple clients, just click to select each individual client. You can also use
Select All and Unselect All on the top of the Client list to select/unselect clients.
6. On completion, the client(s) is managed by your ViewSonic Device Manager.
NOTE
• Whichever group you add a client to (including Ungrouped), once Put in group
is executed successfully, the client will be managed by your ViewSonic Device
Manager.
3.3.6 Creating and Managing an IP Range List
You can define different IP ranges for your local network, and then discover unmanaged clients within a specific
range of IP addresses when needed.
Creating an IP Range List
To create an IP Range list, please do the following:
1. On Scan tab, click to check Scan by List of IP Ranges.
2. Click Add on the top of the IP Range list.
3. The Add window appears.
4. Type in the name for this entry of IP range, and specify the desired IP range using From and To elds.
5. Click Save to add this range entry.
6. Repeat steps 2 through 5 to add other range entries to your IP Range list.