Specifications

50" from ground.
• Aluminum one piece extruded 6005-T5 alloy 3" x 3" wall beams on 24” centers, 0.125
wall thickness. Studs feature machined wire pass-throughs, and raised adhesive control
features on base.
• Beams shall be chemically bonded to sidewalls eliminating the need for rivets. Buck-
rivets will be used to fasten the top and bottom rub rail. Use of two-sided tape is not
acceptable.
• Body shall have 0.125" strain-hardened aluminum alloy 5052-H36 side panels. The
upper panels shall be free of rivets allowing for smooth graphics application.
• Fender flares, 1.38" x 2.25" x 0.090" roll formed and radiused 5052-H32 aluminum
sheet, mechanically fastened to wheel opening. Edges sealed against moisture.
• NFPA 1901 embossed 0.125" aluminum tread plate roof attached to 3" x 3" extruded
aluminum roof bows on 16" centers. Bows shall be 2” skip welded every 12”. Tread plate
seams to be continues welded. Perimeter of roof shall be chemically sealed.
• Lift-up molded fiberglass hood with non-corrosive grill insert. Hood shall have
integrated headlamps and turn signal indicators and dual assist gas charged lift shocks.
The use of mechanical assist springs is not acceptable.
• Extruded aluminum floor with interlocking planks, 1.88" high x various widths, 0.125"
top surface. 6005-T5 alloy and temper. Heavy-duty thick-wall extruded planks fore and
aft of all floor cutouts and every 5th plank in all other areas. Planks made of 6005-t5
alloy and temper, 0.250" thick top surface.
• Bright polished front bumper.
• Tinted safety plate glass windshield chemically bonded to body with driver and
passenger sun visors.
• Full width 12" deep heavy-duty one piece aluminum rear bumper with center step,
painted to match the body.
• Integral cab air conditioning and heating system with dash controls.
• Velvac heated remote control rear view mirrors with dash controls. Upper mirror has
62-sq.in. of flat surface and lower mirror has 30-sq.in. of convex surface. Mirror has a
fold-away arm.
• Driver seat shall be Seats Inc. Magnum 200 mechanical suspension seat on fixed
pedestal. Seat shall be covered in black cloth and have arm rests, lumbar support, tilted
back and 3-point seat belt.
• Passenger seat shall be Seats Inc. Magnum 200 mechanical suspension seat on fixed
pedestal. Seat shall be covered in black cloth and have arm rests, lumbar support, tilted
back and 3-point seat belt.
• Intermittent windshield wiper/washer with single heavy-duty windshield wiper motor.