Specifications

• Cover cab doors with one piece aluminum panels. Upper half to be wrapped with vinyl
and lower half to be wrapped with padded vinyl.
• 10" high 0.100" bright aluminum tread plate kick plate at bottom of doors.
• Heavy-duty rubber grab handle on each door.
• Panels covered with vinyl above driver and passenger doors.
• Vehicle height sign on dash.
• Insulated black rubber mat in driver and passenger toe plate area. Insulate walls in toe
plate area and install carpeted panels.
• Vehicle shall have a Final Stage Vehicle Certification and Altered Vehicle Certification
as required by Federal Motor Vehicle Safety Standards (FMVSS) 49 CFR Part 567.5 and
567.7
• Payload sticker in cab area with vehicle axle load ratings and available axle payload as
built.
Work area on passenger side of cab shall be custom shaped and wrap around to extend by
drivers area and be constructed of 5/8" plywood covered to match rear counter-tops and
trimmed with vinyl T-molding.
Overhead console with lockable storage doors shall be installed above driver and
passenger area. The entire console shall be constructed of 3/4" plywood. The face shall
be finished with black laminate and the bottom shall be covered with padded vinyl.
Red LED/Clear incandescent dome light with 3-position switch, red/off/white mounted
under center of console.
Pioneer DEH-P4800MP or approved equal, MOSFET 50-watt x 4, CD/MP3/WMA/WAV
Receiver with 3-band parametric EQ or approved equal, and one (1) pair of Pioneer TS-
A6971R or approved equal, 6" x 9" three-way speakers mounted in cab.
Zone Defense color back up camera system with 7" LCD monitor with day/night camera
or approved equal.
ABS recessed cup holders for driver and passenger.
WALLS, CEILING AND FLOOR:
Insulate walls with a minimum 3" of fiberglass insulation. Cover interior body side posts
with 1/2" plywood sub wall,
Cover each sub wall with silver smooth finish Kemlite 0.075" fiberglass reinforced plastic
(FRP) lining. No seams from cab to rear of truck.
Insulate ceiling with a minimum of 3" of fiberglass insulation. Cover interior roof beams
with three (3) piece modular panel ceiling. Panels to be made with 1/2" structural
plywood, Exposure 1-APA, 5 ply, face veneer plugged and sanded. Meets California Air
Resources Board (CARB) phase 2 requirements. Modular ceiling panels to be covered
with Silver Haze fabric. Center section from front of truck to rear of truck shall be laid
over the side panels and be removable for future upgrades.
5/8" exterior grade tongue & groove plywood with a water proof moisture barrier
underlayment for floor.
Lonseal Loncoin II Flecks 150 Onyx or approved equal, non-skid commercial grade PVC
flooring. The flooring shall be continuous, one piece full length, full width, no seams.
2-1/2” vinyl cove molding where walls meet floor.
Hinged step well cover on passenger side.