Specifications

• NEMA 4 plastic enclosure: 5.14"(H) x 4.00"(W) x 2.45"(D)
• LED Visual verification of status
A multiplex controlled power and data electronics system must be incorporated into a
common touch screen with the ability to distribute and control strategic on board systems.
It also simultaneously allows distribution of the information to multiple onboard
control/monitoring stations. This system is required as it simplifies start up procedures,
contains fewer operating components, reduces operational start-up time, reduces the total
amount of wiring in the vehicle and has error detection protocols and troubleshooting
features.
Multiplex system features:
• Two (2), 10” LCD touch screens with custom graphics for control and monitoring at
separate control stations in the front and rear of the truck
• Touch pads with custom graphics for local control of HVAC and lighting in center
rooms and exterior as applicable.
• Mobile device (tablet) integrated to multiplex electronics system.
• AC power distribution control and monitoring for the generator with power management
• DC power distribution control and monitoring with I/O channels and three battery banks
• Manual or automatic generator control
• HVAC temperature control in each section of the truck and on front and rear LCD touch
screens
• Lighting control Day/Night mode in each section of truck and on front and rear LCD
touch screens. Note: Each zone shall have three 3 modes. 1 - red/night mode, 2 - white, 3 -
reduced white.
• Automatic power transfer switches
• Automated startup and shutdown procedures which allow all operators to get all systems
operational in the same order every time in less than 10 minutes
• Seamless control of generators, lighting, awnings and additional devices
• Mast control
• Safety interlocks will not allow vehicle to start when exterior equipment is deployed up,
out, or down
• System shall identify wrong AC voltage plugged into vehicle and stop power from
leaving system and reaching equipment
• The system must be completely upgradeable with power modules located throughout
vehicle. Additional components may be added to system with a simple
software modification
System capability is not to be achieved with use of multiple monitoring systems designed
for specific use i.e. water monitors, battery monitors etc.
Marinco 50A-125/250Vac waterproof shore power inlet, 50-ft. 50A-125/250Vac shore
power cord and 6-ft. 50A-125/250Vac pigtail.
Fourteen (14) specification grade 20A-125Vac duplex receptacles not dedicated to any
installed equipment.
Four (4) specification grade 20A-125Vac exterior GFCI duplex receptacle with
weatherproof PVC cover.
Wire chase wire management large capacity double raceway connecting all work stations.