User guide

Other Information
32
Problem Possible Solution
Remote control unit does not
operate
Make sure the batteries are inserted correctly.•
Batteries could be weak or dead. Replace with new batteries.•
Checkifthereisauorescentlightilluminatedneartheremotecontrol•
sensor.
The path of the remote control beam may be blocked. Make sure the •
path is clear and that the remote control is aimed at the remote control
sensor on the TV.
Press •
on the remote control to see if you can turn on the TV.
Press • MENU on the remote control to see if there is an OSD menu
shown on the screen.
Press only one button at a time and it is the correct one for the •
operation you want to perform.
Unit cannot be operated
Externalinuencessuchaslightningorstaticelectricitymaycause•
improperoperation.Inthiscase,operatetheunitafterrstturningon
the power of the TV and the AVC System, or unplug the AC cord for 1
to 2 minutes, then replug again.
Power is cut off suddenly
Make sure the sleep timer is turned off.•
Make sure the PC or video signal cable is connected properly.•
The internal temperature of the unit has increased. Remove any objects •
blocking the vent or clean as necessary.
No CATV reception (or no
reception above CH13)
Set the correct • Signal Type (Air / Cable) on the Channel menu.
CATV is connected improperly or not connected; please check all the •
CATV connections.
The cable TV service is interrupted; please contact your cable operator.•
Adjust the location of the antenna, place it far from roads or sources of •
interference.
Picture is cut off/with sidebar
screen
Make sure the video signal cable is connected properly.•
Adjust the • Screen Size setting on the Picture menu.
Press • ASPECT repeatedly on the remote control to switch to the
display mode you prefer.