User guide

28 2928
Wall-Mounting
Please install on a wall by using a Wall-Mount Bracket (sold separately). Before
mounting the TV on a wall, the stand must be removed from the TV. Follow the simple
steps below to remove the stand:
1. Disconnect all the cables from the TV.
2. Gently lay the TV face-down on a level and stable surface covered with a thick and
soft cloth. Make sure the stand is hanging over the edge.
3. Remove the four screws that secure the cover, then remove the cover and the
stand.
4. Secure the at stand cover to the back of your TV using the four screws you just
removed.
5. Do not remove the stand for any reason other than to Wall-Mount the TV.
6. Be sure to store the removed screws and stand in a safe place until you are ready
to reattach the Table-Top Stand. Keep the screws away from small children.
7. For bracket installation, refer to the instruction guide provided by the Wall-Mount
Bracket model for your TV. Sufficient expertise is required in installing this TV,
especially to determine the strength of the wall for withstanding the TV’s weight.
8. For product protection and safety reasons, ViewSonic strongly recommends
that you use the Wall-Mounty Bracket model designed for your TV and the Wall-
Mounting of your TV should be performed by ViewSonic dealer or licensed
contractor.
Note:
200 mm x 100 mm (32”) wall mount bracket is not included. Please contact your local
distributor.
Note:
400 mm x 400 mm (42”) wall mount bracket is not included. Please contact your local
distributor.