Instruction manual

2. IP PVMZ Installation and Basic Setup
2.1. Before Installation
- Read carefully User's Manual.
- Check User‟s Network (IP Address, Network Mask and default gateway)
- Secure IP address for IP PVMZ.
2.2. Factory Default Settings
The following table shows the factory default condition.
Please refer to this when you need to change the values on admin menu.
Factory Default
Admin ID
root
Admin password
root
IP address
10.20.30.40
Network mask
255.255.255.0
Gateway
10.20.30.1
Note : Factory default Admin ID and Password are all lower case letters.
You can change the password with Capital letters.
2.3. Installing IP PVMZ
Following steps are the physical installation process for IP PVMZ.
2.3.1 Fix the IP PVMZ in place
2.3.2 Connect the IP PVMZ to the Internet cable through the LAN port.
2.3.3 Connect the power supply of IP PVMZ.
After that, you need to follow the steps below.
- Network Configuration: Refer to “IP Installer User‟s Manual”
Refer to “IP Camera Admin User‟s Manual”
Refer to “Smart Viewer User‟s Manual”
- 27 -