Instruction manual

Setting up Remote Viewing - Appendix #3

Adding a Site (Individual Unit Configuration)

DVR Information - Enter

the information specific to

the unit (refer to page 30

for setup instructions):

• Name - Enter a name for

the unit.

• IP / Domain Name -

Enter the IP address or

Domain Name for the

System. This will vary

depending on setup

(Internal Network

Connection or External

Remote access through

the Internet)- refer to page

30 for setup details.

• Port - Set to 6100 by

default.

• User ID - Enter the USER

ID to connect to the system

(the USER ID is configured

on the System - i.e. ADMIN

- case sensitive).

• Password - The

password used to access

the System (i.e. The

ADMIN password is set to

1234 by default).

Camera Assign - Set

each camera to a portion

of the 9-view window by

using the drop down

menu selections.

ADD Button - Adds the

site to the Group.

OK Button - Accepts the

changes and Closes the

configuration Window

NOTE: When entering the information for the IP / DOMAIN NAME:

• If you are connecting from within your network (i.e. The System and your PC are both inside

your house), you only need to enter the IP address of the System into the software (i.e.

192.168.0.105)

• If you are connecting from outside your network (i.e. The System is at Home, and your PC is

at work), use the DDNS Domain Name to configure the software).