User Manual

Hybrid Digital Video Recorder
User Manual 5 Setting
26 Issue V1.0 (2016-12-22)
Figure 5-8 IPv4 network setting screen
Step 2 Click the button next to Get IP Automatically to enable or disable the function of
automatically getting an IP address. The function is enabled by default.
If the function is disabled, click input boxes next to IP, Netmask, and Gateway to
set the parameters as required.
Step 3 Click the button next to Get DNS Automatically to enable or disable the function
of automatically getting a DNS address. The function is enabled by default.
If the function is disabled, click input boxes next to DNS1 and DNS2, delete
original addresses, and enter new addresses.
Step 4 Click Check. The system automatically checks network settings and the dialog box
as shown in Figure 5-9 is displayed. Check and connect the network based on
network check results.