User Manual

11User Manual Visit the ViewZ USA website at https://www.viewzusa.com
VOLUME
37
CONTROL AND FUNCTION
Volume
Select Input Source - Monitor Button Function
Press◄ / ► buons of monitor & remote controller to adjust volume
Auto Detect Source / No Signal / Out of Range Message
No Signal Message : If you did not connect any input source, monitor will show 'No Signal' message and go into stand-by
mode.
Input Message : If you connect any input source, monitor will detect it automacally and idenfy it by the type of input
source it is - HDMI, DVI or VGA.
Out of Range Message: If you connect a specic input source that is out of range on panel frequency (ref. page #17), you will
see this message. In this case, please connect proper frequency input source.
Press 'Source' buon on monitor
Press▲ ▼ buons to change input source
If you push 'SOURCE' buon on monitor, you will see all available input sources. If the input source is connected, you will
see it as the selected input source.
INPUT
VGA
DVI
HDMI
ATTENTION
No Signal
ATTENTION
OUT OF RANGE
INPUT
HDMI