Installation manual

ManualsBrandsViewZ ManualsTVs & monitorsVZ-AM01

INSTALLATION MANUAL

Full Motion LED, LCD TV Wall Mount

CAUTION: DO NOT EXCEED RATED

LISTED WEIGHT CAPACITY. SERIOUS

INJURY OR PROPERTY DAMAGE MAY

OCCUR!

ISSUED: MAY. 2013

27"

MAX

75x75/100x100

LCD-101

15kg

(33lbs)

RATED

15kg

(33lbs)

RATED

Summary of content (4 pages)

PAGE 1
INSTALLATION MANUAL Full Motion LED, LCD TV Wall Mount CAUTION: DO NOT EXCEED RATED LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR! LCD-101 75x75/100x100 27" MAX 15kg (33lbs) RATED ISSUED: MAY.
PAGE 2
NOTE: Read the entire instruction manual before you start installation and assembly. Component Checklist IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, telephone your local distributor for a replacement. WARNING • Do not begin the installation until you have read and understood the instructions and warnings contained in this installation sheet.
PAGE 3
1b. Solid Brick and Concrete Mounting 1a. Wood Stud Wall Mounting 50mm (2") ( 2") 55mm ((2.2") 2.2") ø 4mm (ø 5/32”) 1 ø 8mm (ø 5/16") 2 1 Find and mark the exact location of mounting holes Mark the exact location of mounting holes 2 3 Drill pilot holes Drill pilot holes √ W-A X X √ W-B X X W-A Screw the wall mount onto the wall Screw the wall mount onto the wall WARNING • Make sure that mounting screws are anchored into the center of the studs.
PAGE 4
2. Attach the Display to the VESA Plate M-C M-A/M-B Tension is pre-set at the factory. If too tight or too loose, you may adjust the tension by loosening or tightening the head and arm adjustment bolts. B 180° 180° 180° +70° -70° Lift the display and match the holes on your display with the holes on the mount. Secure your display to the mount by tightening screws. Tighten all screws but do not over tighten. 3. Adjustment Adjust to the desired location or tilt.