User Manual

14 User ManualVisit the ViewZ USA website at https://www.viewzusa.com
Change IP Address
1.3. IP Setting Software
• If you want to congure the IP address of VZ-PRO Controller, please use the IP address seng soware.
• On the network system, you shuold use the proper IP address for VZ-PRO Controller.
1. Launch IP seng soware - 'SearchNvsDemo' (it will be loaded on the desktop aer this installaon) to setup
the IP address of VZ-PRO controller, if you have mulple VZ-PRO controllers in the network.
2. On the desktop of PC (which WTRemote program was installed) and nd 'IP Seng SW'icon & double click it.
CONTROLLER IP ADDRESS
3. Then, the Device Network Parameter Sengs window will pop up.
4. Click the Search Device buon on the top.
5. Then, you can see the info of connected VZ-PRO Controller and click Parameter Seng buon to modify the
info.
6. You can put the IP address/Subnet Mask/Gateway info and click OK to save/update the info.
7. If connecon is failed, you cannot see the listed VZ-PRO Controller. In this case, please check the cable, router
setup or network administrator.