User Manual

55User Manual Visit the ViewZ USA website at https://www.viewzusa.com
Maintenance
C0NTROL OPERATION
6.7. Maintenance - Decode & Encode
6.8. Maintenance - Pocket Format
6.9. Maintenance - Com port Setup
• About the Decode and Encode, please refer to page 41 - Decoder seng and page 42 - Preview display seng.
• The center management plaorm send COMMANDS to the VZ-PRO Controller or the VZ-PRO Controller send
responses to the center management plaorm.
The data will collect all data pocket, the data pocket format start with $ and end with ^ character.
OP means operate commands, one char.
SCAR means the screens group numbers, one char.
• Set the Port and Baud rate as the picture below
Serial data format is UTF-8 hex characters.
Parity check: Noparity
Databits:8
Stop bit:1
$ OP SCAR DATA ^