IMPORTANT: DRIVESHAFT INSTALLATION
GET TO KNOW THE DRIVESHAFT LEFT NUT RIGHT NUT CENTER ROD
GET TO KNOW THE FRAME LEFT COLUMN RIGHT COLUMN WITH WITHOUT MOTOR MOTOR
Step 8: Turn the LEFT NUT counterclockwise to remove it from the DRIVESHAFT. Keep the PLASTIC GROMMET inside the LEFT NUT.
Step 8: Insert the LEFT NUT and PLASTIC GROMMET into the LEFT COLUMN. Pay attention to the insert direction.
Step 8: Insert the DRIVESHAFT into the LEFT COLUMN. Push the DRIVESHAFT all the way in.
Step 9: Slightly loosen the RIGHT NUT by turning it once around. DO NOT REMOVE THE RIGHT NUT.
Step 8: Turn the LEFT NUT clockwise to firmly lock the DRIVESHAFT in place. Leave a small gap (about 0.2in) between the LEFT NUT and the LEFT COLUMN so they won’t block the DRIVESHAFT when it turns.
Step 10: Pull the CENTER ROD out and insert it into the RIGHT COLUMN
Step 11: Push the CENTER ROD all the way in. Then leave a small gap (about 0.2 in) between CENTER ROD and RIGHT COLUMN FAR WALL. LEAVE SOME A SMALL GAP (0.
Step 12: Turn the RIGHT NUT to lock the DRIVESHAFT in place. Do not let the RIGHT NUT touch the RIGHT COLUMN.
Step 12: Use the wrench to tighten both LEFT NUT and RIGHT NUT TIGHTEN LEFT NUT TIGHTEN RIGHT NUT
Step 12: Connect the CONTROL BOX and SMART KEYPAD to your SmartDesk
Step 12: Almost done :) Turn on your SmartDesk by holding both the UP and DOWN buttons for 20 seconds until you hear a BEEP sound.
IMPORTANT: DOUBLE CHECK YOUR DRIVESHAFT INSTALLATION
Step 12: Press UP to raise your SmartDesk up. Press Down to lower your SmartDesk. Repeat it a few times.
CHECK 1: There is a still small gap (about 0.2 in) between the LEFT NUT and the LEFT COLUMN. If not, adjust the LEFT NUT location. Tighten it with the wrench.
CHECK 2: There is still a small gap (0.2 in) between the CENTER ROD and the wall of the RIGHT COLUMN. If not, adjust the RIGHT NUT and CENTER ROD. Tighten the RIGHT NUT with the wrench. LEAVE SOME SPACE BETWEEN THE RIGHT NUT AND RIGHT COLUMN LEAVE SOME A SMALL GAP (0.
CHECK 3: There is a gap between the RIGHT NUT and the RIGHT COLUMN. If not, adjust the RIGHT NUT. Tighten it with the wrench.
CONGRATULATIONS! You’re now a driveshaft installation expert!