Instruction manual

MULITI WINDOW:
OFF.PIP. POP
The default value is off, Lets you
select your window for the picture:
PIP . POP
Care and Cleaning
CAUTION: Turn off your MONITOR before cleaning.
You can clean the MONITOR as required, using a soft lint-free cloth. Be sure
to occasionally dust the ventilation slots in the cabinet to help assure
adequate ventilation.
The MONITOR’s screen may be cleaned with a soft, lint-free cloth as well.
Take care not to scratch or mar the screen. If necessary, you may use a cloth
dampened with warm water. While cleaning do not spray liquid directly on the
screen, or allow liquid to run down the screen and inside the Monitor. Also,
never place drinks or vases with water on top of the monitor. This could
increase the risk of fire or shock hazard or damage to the monitor.
Mounting Your MONITOR to the Wall
Caution: The wall mount must bear a minimum of five times The monitor’s net
weight without causing damage. To mount your MONITOR to the wall you
need to purchase a VESA wall mount. For models 15inch. 17inch .
19inch.20inch, purchase a VESA 100 x 100, KM4x 8mm (100 x 100, for
example, means the mounting measurements are 100mm horizontally and
100mm vertically; M4 x 8 mm is the type screw that needs to be used).
1.You need to remove the base first before attaching the wall mount.
A. Place the MONITOR face down on a surface that is soft, yet strong
enough to hold the MONITOR.
B. Use a screwdriver to remove the screws from the four holes on
each side of the bottom of the MONITOR’s base (only use with base)
2.Make sure all cables are already connected to the MONITOR.
3.Follow the directions included with the wall mount to mount the
monitor to the wall.
18
17