Installation Guide

This product meets the CEC requirements. It is up to the discretion of the client to modify the product with the

provided restrictor. Doing so will remove the ability for the product to meet certain low flow standards. Please talk to

your local or statewide plumbing enforcement agency prior to modifying. Vigo is not responsible for any alterations

and the affects that may come with altering the product post sale and highly advises that the client only install the

product that meets the needs of their local plumbing code.

Flow rate with installed restrictor - 1.2 gpm

Flow rate with restrictor provided in box - 1.5 gpm

FLOW RATE REGULATIONS

Loosen the two set screws at the bottom of the spout. Pull

the spout off of the faucet. Pull the face plate away from the

wall.

Unscrew and remove the brass connector with the pink 1.2

gpm restrictor inside.

Replace with the brass connector with the orange 1.5 gpm restrictor

inside by screwing it back in. Replace the face plate and spout by

tightening the two set screws at the bottom of the spout.

Brass connector

Face plate

Brass connector