User Manual

6
5
FIG. 9
FIG.10
4
5
13
12
THIS END MUST
LOOK INSIDE THE
SHOWER
13
5
10
MODEL VG06031
12
F. INSTALLING THE WATER SEAL STRIP
1. Place the seal strips (#12 and13) to the door and to the fixed panel, respectively. [SEE
FIG.10]
2. Trim the flange on the seal strips (#13) so that there is enough clearance for the door to roll
without the seal strips hitting against the rollers or door stopper.
TRIM HERE
E. INSTALLING THE HANDLE
1. Unscrew the handle holders from the handle assembly
(#6).
2. Place the handle to the position on the door. Place
plastic washers (supplied) on each side of the door.
[SEE FIG.9]
3. Tighten the handle nuts from inside the shower.
4. The door stopper's position (#10) may have to change
now to stop the handle from hitting the fixed panel when
in the open position. Adjust accordingly. [SEE FIG. 10]
10
ADJUST POSITION
TO STOP HANDLE
FROM HITTING
FIXED PANEL