Instructions / Assembly

5
TROUBLESHOOTING
PROBLEM POTENTIAL CAUSE CORRECTIVE ACTION
1 - Leaks from handle
2 - Insufficient flow rate
3 - Leak at connection points
4 - Loose faucet body
PARTS LIST - For any parts needed but not shown, please contact Vigo Technical Support
PART
TOLL FREE: (866) 591 - 7792
E-Mail: [e-mail]
www.vigoindustries.com
PART # FINISH
SUPPLY DATE INDICATOR (INTERNAL USE ONLY)
1.A - Cartridge unseated
1.B - Cartridge defective
2.A - Dirty aerator
2.B - Clog in supply hose / line
3.A - Sprayer hose not tight
3.B - Flexible hose leaking at body or connection point
4. - Metal nut became loose
3.A - Remove sprayer and check integrity of the black washer.
Make sure the washer is seated properly and retighten.
2.B - Remove sprayer or supply line and flush lines
2.A - Remove and soak / clean with a non abrasive agent (i.e.
vinegar).
1.B - Contact Vigo Technical Support for replacement.
1.A - Remove cartridge from housing, wash thoroughly with hot
water and reseat in housing.
3.B - Tighten hoses. If this does not resolve the issue, remove
the flexible hose and rethread, checking to make sure the
connection is secure. Make sure to use pipe tape.
4. - From under the counter, use an adjustable wrench and
tighten the metal nut to the hollow pipe. Make sure the faucet is
perpendicular to the counter.
W
ST, ARB
78038
Sprayer
Handle Set Screw
Sedal Cartridge
Metal braided Hose
Handle Lever
Pull out Hose (black nylon)
74019
ST, ARB
W
ST, ARB
W78039A
78039C W
ST, ARB
74040 - W
74020 W-
5 - Sprayer button stops working
5.A - Debris in aerator
5.B - Wear and tear on button
5.A - Remove and clean aerator.
5.B - Contact Vigo Technical Support for replacement.
Handle
78039B W
ST, ARB
NSF / ANSI 61
Sprayer Washer
W74008 -
Black Washer with Screen W74010 -