Installation Guide

MODEL VG06043
12
8. Slide the bracket body in position on the
structural rail. Align the plates to the rail
and slide the bracket body over the plate.
Lock the bracket body to the plate with the
supplied allen key (note the screws should
be at the top of the rail). Make sure the
structural rail is level. If the rail is not level
then loosen the bracket body, slide out of
the way and adjust the plate as needed.
There is a 5mm adjustment built in.
9. Confirm the fixed panel is installed and level
and secure the bottom door guide. Mark
the hole locations of the door bottom guide
on your curb. Carefully raise the fixed
panel and slide the bottom door guide out.
Pre-drill and sink plastic anchors (#15).
Place the bottom door guide back into
place and secure with phillips screws (#17).
B8
PLATE
HEX
SCREW
(ON TOP)
BRACKET
BODY
10
PLATE
1
10
1
B9
PLATE
5mm
VIEW FROM TOP
INSIDE OF THE SHOWER
OUTSIDE OF THE SHOWER
4
7
17
15
7
13
4