Installation Guide

MODEL VG06045

IMPORTANT

ROLLER ADJUSTMENTS TO ACCOMMODATE OUT OF SQUARE OPENINGS

1. Loosen the roller height adjustment screw to allow for movement. [See Fig.1]

2. Fig. 1A displays the 2 different positions.

3. If your walls are plumb and level, follow the configuration in Fig. 2.

4. In the case that your wall is off on the top, the rollers should be adjusted as shown in Fig. 3.

5. In the case that your wall is off on the bottom, the rollers should be adjusted as shown in Fig. 4.

FIG. 1A

IMPORTANT

NOTE: These adjustments are approximate. You may need to adjust the roller height adjustment

screw to meet your needs.

NOTE: There is an adjustment on the roller to accommodate walls that are not 100% plumb.

The bottom screw on the face of the roller adjusts the height of the ball bearing inside. Loosen

this screw, adjust to desired closed door position and tighten in place. You may need to remove

door unit from install to modify height.

ROLLER (3)

ROLLER HEIGHT

ADJUSTMENT SCREW

FIG. 1

Lowest position Normal position Highest position