Use and Care Manual

IMPORTANT

 Verify that the overall size of the shower door opening is appropriate for the shower enclosure.

 Due to individual site variations, exact guidelines for every situation cannot be supplied. The

recommended framing and dimensional requirements are shown for a typical application and

may vary depending on the site requirements.

 To prevent damage to the finish, you should protect the shower cabin bottom with a cardboard

protector before beginning the installation.

 Ensure that there is sufficient structural support behind

the shower wall to hold the weight of the shower door. If

there is insufficient enough support, then reinforce the

shower walls with wooden studs prior to shower door

installation. [SEE FIG. 1]

STUDS

FIG.1



MODEL VG06046

INSTALLATION STEPS

*NOTE: Prior to any installation, mark

lines on the floor and wall for proper

dry fit. Proper planning is imperative

for proper installation. The

measurements of 70.87" and 71.85"

should just be used as a guide. Your

actual dimensions may vary.

A. INSTALLING THE STRUCTURAL RAIL

1. Arrange the glass according to the

configuration you've chosen from page 4 and

lace the inner door panel (#7) into the

shower first making sure to rest the glass in a

manner that the glass or base/tub does not

incur damage. Make sure you have the

inner door facing right side up before

proceeding.

INNER DOOR

PANEL (#7)

INSIDE OF

THE SHOWER