Installation Guide

10
MODEL VG6048
HEX SCREW
SIDE GLASS
PANEL (10)
DOOR (14)
THIN
GASKET
VIEW FROM THE TOP
HINGE (7)
OUTSIDE OF
THE CABIN
INSIDE OF
THE CABIN
PLATE
THIN
GASKETS
THIN
GASKET
SEAL STRIP
(5 or 24)
VIEW FROM
INSIDE
C1
DOOR PANEL INSTALLATION REQUIRES TWO
OR MORE PEOPLE TO ASSIST
C. INSTALLING THE DOOR
1. Clean the door panel (#14) edge where the
seal strip is to be installed with rubbing alcohol.
If your shower opening is 60" attach the door
side seal strip (#5) to the door panel (#14).
Verify that the soft flange of the seal strip (#5)
faces toward the inside of the shower cabin
before seal strip installation. If your shower
opening is 61" attach the extended door side
seal strip (#24) to the door panel (#14). Make
sure to start 3/8" from the bottom of the door
panel. Install the seal strip according to the
diagram.
Note: It is imperative to pick the correct
seal strip here depending on your shower
opening width. This will prevent any water
leakage.
NOTES:
1. If the seal strip is not flat and is twisted, soak
the strip in hot water and press the seal strip
back into position.
2. Part #5 is reversible and pre-cut on top and
bottom to fit in proper configuration.
Cutting/finishing is needed but only after
fully installing and only at the top of the unit.
2. Place the door on a 5/8" shim (not provided).
Install the top hinge first for safety and ease
of install. Position the door onto the hinges.
Hold securely in place using shims. The seal
(#5) may get stuck between the two panels of
glass. Pull the seal out of the groove using
your fingers and nothing sharp, making sure
not to damage the seal. Tighten allen key
screws. Install the hinges as illustrated. Use
the hex key supplied. Adjust hinge so the
gaps are equal at top and bottom and pull
door panel away from side glass panel (#10)
to allow the door to swing freely without
crimping seal strip (#5).
THIS SIDE MUST
LOOK INSIDE
THE CABIN
14
C2
OUTSIDE VIEW
3/8"
[10mm]
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
!
5
24
or