Installation Guide

14
MODEL VG6048
4. Open the door (#14) and remove the
magnetic seal strip (#8) from the vertical
rail (#20). Position the vertical rail (#20)
along the wall where you marked, making
sure the bottom rests on the floor. Mark
holes on the wall for mounting screws.
5.
Remove the
vertical rail (#20)
. Drill holes
into the respective marks and insert white
plastic anchors (#2) inside them.
Not necessary if installing into studs.
Studs are the preferred means of
installation, anchors can pull out of the
wall causing property damage and
bodily harm.
D4
!
D5
20