Installation Guide

16
E. INSTALLING THE STRUCTURAL ARM
E1
1. Install the support assembly (#17) onto the
side glass panel (#10) approximately half
way away from the wall. Do not tighten.
2. Install the structural arm (#6) to the support
assembly (#17). The wall connector (#9)
should be attached to the other side of the
structural arm (#6). Slide the support
assembly towards the wall until the wall
connector (#9) is flush with the wall. Make
sure it is level. Mark the location of the wall
connector along the wall.
WALL
SIDE PANEL
OUTSIDE OF
THE CABIN
WALL
E2
17
SIDE PANEL
MODEL VG6048
SIDE PANEL
WALL
17
9
6
LEVEL