Installation Guide

17
3. Remove the support assembly. Position the
wall connector (#9) back to where you
marked the wall and mark a hole on the wall
for the wall connector plate.
4. Remove the wall connector (#9). Drill a hole
into the respective mark and put a plastic
anchor (#2) in it. Not necessary if
installing into studs. Studs are the
preferred means of installation, anchors
can pull out of the wall causing property
damage and bodily harm.
5. Replace the wall connector plate to the
proper position. Screw it into the wall with 1
5/8" screws (#1). There is a 5mm
adjustment built into the wall connector
plate for minor modifications.
E3
E4
E5
MODEL VG6048
SIDE PANEL
WALL
9
!
SIDE PANEL
WALL
2
SIDE
PANEL
WALL
1
There is a 5mm adjustment
built into the plate.
5mm