Installation Guide

19
MODEL VG6048
G. INSTALLING THE THRESHOLD
1. Position the right threshold clip (#18) at the
bottom of the vertical rail (#20). Mark the
location for the mounting hole.
2. Remove the right threshold clip (#18). Drill a
hole into the respective mark and put a
plastic anchor (#12) in it. Not necessary
if installing into studs. Studs are the
preferred means of installation, anchors
can pull out of the wall causing property
damage and bodily harm.
3.
Slide the door threshold (#13) into the left
threshold (#19). Replace the right threshold
clip (#18) to the proper position. Screw it
into the floor with 3/4" screws (#16).
Note: Confirm the position of the
magnetic seal strip (#8). The magnetic
seal strip must rest on the right
threshold clip (#18).
G1
18
20
8
G2
!
20
8
12
G3
16
12
18
13
19
8
20