Installation Guide

H. INSTALLING BOTTOM DOOR SEAL STRIP

1. Clean the door glass panel (#14) edge where

the door bottom side seal strip (#11) is to be

installed with rubbing alcohol. Verify that the

soft flange of the seal strip faces toward the

inside of the shower cabin before seal strip

installation. Install the seal strip according to

the diagram.

NOTES:

1. If the seal strip is not flat, use a hair dryer to

apply minimal heat and press the seal strip back

into position.

2. Adjust the magnetic seal strip (#8) and the door

side seal strip (#5) to the correct height over the

door bottom seal strip (#11) and cut to the needed

height at the top of the panel.

I. INSTALLING COVERS

1. Install screw covers (#21, #22 and #25) to

the unit. Please pay attention that there

are three types of covers. The 8mm

screw covers (#21) are for the threshold

clips (#18 & #19). The 4mm screw

covers (#22) are for the wall connectors

(#9), hinges (#7) and the support

assembly (#17). The 10mm screw covers

(#25) are for the handle assembly (#15).

Install the glass support covers to the

glass supports (#3).

MODEL VG6048

OUTSIDE OF

THE CABIN

8mm

4mm

10mm