Installation Guide

7
MODEL VG06051
INSTALLATION STEPS
*NOTE: For ease of installation, place
the door panel (#7) on the inside of the
cabin before starting. The
measurements of 69 1/2", 70 1/4", 33
3/4" should just be used as a guide.
Your actual dimensions may vary.
A1
A.
INSTALLING THE SIDE GLASS PANEL
1. Arrange the glass panel to the preferred
configuration (see diagram on pg.5). Install
the seal strip (#18) to both sides of the side
glass panel (#6). The seal strip (#18) that is
not against the wall needs to be cut below
the structural rail at a height of *69 1/2".
The structural rail will install through the
small notch on the side glass panel (#6).
2. Screw the glass support (#20) to the side
glass panel using the hex key (supplied).
Use a washer on each side of the panel.
3.
Place the structural rail screw (#17) into the
side glass panel and screw together with the
structural rail (#16). NOTE: A minimum of
2 people will be needed to perform this
step.
18
WALL
SIDE
DOOR
SIDE
6
18
18
18
6
15
16
A2
THIN
GASKETS
20
20
A3
18
6
15
16
20
17
69 1/2"