Use and Care Manual

10
MODEL VG06064
2. Place gaskets on each side of the side glass
panel (#10). Position the bottom hinge on
the side glass panel as shown. Screw into
place with the set screws.
B2
10
7
21
7
GASKETS
10
PLATE
C1
1. Clean the door glass panel (#14) edge where
the door side seal strip (#5) is to be installed
with rubbing alcohol. Verify that the soft
flange of the seal strip faces toward the inside
of the shower cabin before seal strip
installation. Install the seal strip according to
the diagram, making sure the bottom of the
seal is flush with the bottom of the door.
NOTES:
1. If the seal strip is not flat or twisted, use
hot water and a hair dryer to apply
minimal heat and press the seal strip back
into position.
2. Part #5 is reversible and pre-cut on top
and bottom to fit in proper configuration.
Cutting/finishing is needed but only after
fully installing and only at the top of the
unit.
C. INSTALLING THE DOOR PANEL
WARNING
!
DOOR PANEL INSTALLATION REQUIRES
TWO OR MORE PEOPLE TO ASSIST
THIS SIDE MUST
LOOK INSIDE THE
CABIN
5
14
10
16
14
14
THIS SIDE MUST
LOOK INSIDE THE
CABIN
5
VIEW FROM THE TOP
5mm HORIZONTAL
ADJUSTMENT