Use and Care Manual

11
MODEL VG06064
10
7
21
7
SHIM
(NOT PROVIDED)
VIEW FROM
THE SIDE
7
14
14
PLATE
GASKETS
VIEW FROM
THE SIDE
7
14
PLATE
GASKETS
2. Install the hinge pieces (#7) on the door
first. Then raise the glass, making sure the
pin on the hinge (door side) goes into the
corresponding hole in the top hinge on the
fixed panel. The bottom pin should then go
into the bottom hinge on the fixed panel.
Place the door (#14) on shims (not
provided) to hold firmly in place. Tighten
allen key screws using the hex key supplied.
Make sure the door is level from the
end. If the door is not level, adjust the
hinge positions until the door is level.
This being level is imperative to the
installation and will guarantee a tight
seal.
3. Clean the door (#14) glass surface where
the door magnetic seal strip (#8) is to be
installed with rubbing alcohol. Place
magnetic seal strip (#8) to the door. Line
the top of the door to the top of the
magnetic seal strip.The magnetic side
should be facing the inside and the clear
side be facing the outside. The door
magnetic seal strip (#8) is reversible.
Do not install the handle first, this is
dangerous and may cause the glass to
break.
C2
THIS SIDE
MUST BE
LEVEL
C3
10
7
21
7
14
!