Use and Care Manual

14
MODEL VG06064
!
5. Remove the side glass panel. Drill holes
into respective marks and insert plastic
anchors (#2) inside them. Not
necessary if installing into studs. Studs
are the preferred means of installation,
anchors can pull out of the wall causing
property damage and bodily harm.
6. Replace the side glass panel (#16) back
into place and screw it to the wall
with 1 5/8" screws (#1). Tighten the glass
supports (#3) to the side glass panel.
NOTE: One person should be holding
the side panel and door panel closed
(with the magnetic seal strips on) while
the other person screws in the glass
supports. This will ensure a proper
seal. It is important to have a tight seal
at the magnetic seal strips. If the fixed
panel on the magnetic seal side does
not reach the wall you can adjust the
dimension. Loosen the bottom hinge
inside plate and slide the glass until the
magnetic seals are firmly locked. There
is a total of 6mm horizontal adjustment.
D5
2
D6
8
14
MAGNETIC SEAL STRIP
CONNECTION WILL BE HELD
HERE BY ONE PERSON DURING
THIS ENTIRE STEP.
2
2
1
1
16
3
10
21
7
7
10
LOOSEN PLATE
SLIDE
6mm ADJUSTMENT