Use and Care Manual

8
MODEL VG06064
3. Measure *36" or *42" from the corner of the
wall. This will be where you place the side
panel (#10). Make sure glass panel is level
to the wall. Use the level to position
the side glass panel correctly. Make sure
the seal strip is against the wall. Mark holes
on the wall for the mounting screws.
* This measurement will be based off of
the size unit you have. If you have the
36" unit you will measure 36". If you
have the 42" unit you will measure 42" .
4. Remove the side glass panel. Drill holes into
respective marks and insert plastic anchors
(#2) inside them. Not necessary if
installing into studs. Studs are the
preferred means of installation, anchors
can pull out of the wall causing property
damage and bodily harm.
A3
10
!
THIS SIDE
MUST BE
LEVEL
3
*36" or *42"
A4
2
2