Use and Care Manual

9
MODEL VG06064
5. Replace the side glass panel (#10) back into
place and screw the glass supports (#3) to
the wall with 1 5/8" screws (#1). If the panel
is not level from the end, adjust the position
of the glass supports on the glass. This
being level is imperative to the installation.
A5
10
THIS SIDE
MUST BE
LEVEL
3
*36" or *42"
3
2
1
1. Clean the glass surface on the side
glass panel (#10) where the hinges (#7)
are to be installed with rubbing alcohol.
Place gaskets on each side of the side
glass panel (#10). Position the top
hinge on the side glass panel as shown.
Make sure the set screw side if facing
the wall. Screw into place with the set
screws through the support assembly
(hinge side) (#21) with the allen key
provided.
B. INSTALLING THE HINGE TO THE SIDE GLASS PANEL (#10)
B1
10
7
7
21
GASKETS
10
21
SET
SCREW