Use and Care Manual

12
MODEL VG06064
D. INSTALLING SIDE GLASS PANEL (PART #16)
D1
1. Install the side seal strip (#4) to the wall
side of the side glass panel (#16). Install
the magnetic side seal strip (#8) to the
door side. The magnetic side should be
facing the inside and the clear side be
facing the outside. Installing the
magnetic seal strip prior to locating the
place for the glass support allows for
proper seal. It should go all the way to
the bottom of the glass panel in order to
prevent water leakage.
2. Screw in the glass support (#3) to the
side glass panel (#16) using the hex key
(supplied). Be sure to use gaskets on
both sides of the panel. Do not
completely tighten. Leave rather loose
so they can slide on the glass panel.
NOTE:
1. When the Vigo logo is facing out the face
of the glass support (#3) will face out.
4
WALL
SIDE
DOOR
SIDE
16
8
D2
!
16
4
3
OUTSIDE OF
THE CABIN
3
GASKETS
3/8"
[10mm]
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
8
16
GLASS
SUPPORT
FACE