Use and Care Manual

7
MODEL VG06064
INSTALLATION STEPS
GLASS
SUPPORT (3)
GASKET
SIDE GLASS PANEL
HEX SCREW
VIEW FROM THE TOP
WALL
SCREW (1)
OUTSIDE OF
SHOWER
INSIDE OF
SHOWER
1. Arrange glass to the preferred configuration.
(see diagram on page 5) These
instructions are for a right side door
opening configuration. Select the door
opening location on the shower cabin.
Install the side seal strip (#4) to the wall side
of the hinged side glass panel (#10).
2. Screw in the glass support (#3) to the side
glass panel using the hex key (supplied)
making sure to slide it back as far as
possible from the glass before you tighten.
The part that connects to the wall should
face in. Be sure to use gaskets on both
sides of the panel. The glass holes are
elliptical allowing for 10mm out of square.
If your shower stall is out of square
more than 5mm from the top of the glass
to the bottom of the glass then this can
cause the shower to potentially leak and
can cause potential fatal harm.
A. INSTALLING SIDE GLASS PANEL (PART #10)
A1
WALL
SIDE
4
10
A2
OUTSIDE OF
THE CABIN
!
3
GASKETS
10mm
3